Stubborn soiling on the
FlexiClip runners
Never attempt to clean FlexiClip
telescopic runners in a dishwasher.
This would remove the special
grease which is essential for their
smooth functioning.
For stubborn surface soiling or if the
bearings become sticky with spilled
fruit juices proceed as follows:
^
Soak the FlexiClip runners for approx.
10 minutes in a solution of hot water
and washing-up liquid. If necessary
use the back of a washing-up
sponge to remove the soiling. The
bearings can be carefully cleaned
with a soft brush.
Cleaning may cause some
discolouration or fading in places,
however this will not affect the
functioning of the runners in any way.
Cleaning catalytic panels and
liners
Soiling from oil and fat is burnt off
catalytic enamel when very high
temperatures are used in the oven.
The higher the temperature, the more
effective the process.
Exposure to scouring agents,
abrasive brushes or sponges and
oven sprays can cause catalytic
enamel to lose its self-cleaning
properties.
Catalytic enamelled panels and
liners should therefore be taken out
of the oven before using oven spray
in it.
Removing spice, sugar and similar
deposits
^ Remove the back panel, roof liner
and side liners (see relevant sections
later on in this chapter).
^
Clean the back panel, roof liner and
side liners by hand with a solution of
hot water and washing-up liquid
applied with a soft brush.
^
Rinse thoroughly and then leave to
dry before fitting back in the oven.
Cleaning and care
88
To Next Page
Loading...
Need help?
General
