F Start the programme
The Start/Stop button will flash when a
programme is being selected. The
flashing indicates that a programme
can be started.
^
Press the Start/Stop button.
The Start/Stop button will now light up
constantly.
The Perfect Dry indicator will only flash
or light up constantly with the sensor
controlled drying programmes. It will
not come on at all with timed drying
programmes (see "Operating the
tumble dryer").
Please note: The programme duration
shown in the display is an estimate and
can vary.
Before the end of a programme
There is a cooling down phase at the
end of the drying sequence (Cooling
down will light up). The programme is
not finished until the cooling down
phase has been completed.
G Remove the laundry when the
programme has finished
0 and Finish will appear in the display
to indicate that the programme has
finished. The buzzer (if selected) will
sound at intervals.
The drum will continue to rotate at
intervals for up to two hours to prevent
laundry creasing, if you do not wish to
remove it immediately (anti-crease
phase). There is no anti-crease phase
at the end of the Woollens programme.
The dryer has a standby mode: after
the programme has finished the display
will go out and the Start/Stop button will
flash slowly. See also "Programmable
functions".
^
Press the Door button.
^
Open the door.
^
Remove the laundry.
Check that all items have been
removed from the drum. If items are
left in the dryer, they could be
damaged by overdrying when the
dryer is next used.
If the dryer is switched on at the mains
and the door is opened, the drum
lighting will come on. It will go out a few
minutes later to save energy.
^ Press the jk button to switch the
dryer off.
^ Clean the fluff filters.
^ Close the door.
^ Empty the condensed water
container.
We recommend connecting the dryer
for external drainage as you will not
need to empty the condensed water
container.
How to dry correctly
19
To Next Page
Loading...
Need help?
General