Reset button
The reset button has two functions:
• Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS
configuration.
• Or Keep holding the button for 5 more seconds until LED turns off, then release it to make the
RouterBOARD look for Netinstall servers.
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed
before power is applied to the device. Useful for RouterBOOT debugging and recovery.
Mounting
The device is designed to use indoors and it can be mounted in a rackmount enclosure using provided rack
mounts, or it can be placed on the desktop. Use a Phillips screwdriver to attach rackmount ears on both sides of
the device if designated use is for rackmount enclosure:
1. Attach rack ears to both sides of the device and tighten four screws to secure them in place, as shown on
the picture to the right;
2. Place the device in rackmount enclosure and align with the holes so that the device fits conveniently;
3. Tighten screws to secure it in place.
The IP rating scale for this device is IPX0. The device has no protection from water contamination, please
ensure the placement of the device in a dry and ventilated environment. We recommend Cat6 cables for
our devices.
Operating System Support
The device supports RouterOS software with the version number v6.46 at or above what is indicated in the
RouterOS menu /system resource. Other operating systems have not been tested.
See mikrotik.com/products for the latest version of this document. Document #52723 Modified on: 11.DEC.2019
To Next Page
Loading...
Need help?
General
Weight and Dimensions
