RBM33G
RBM33G
First use
(Optional) Install the device in a case.
Connect cables to wireless cards and Ethernet ports.
Plug-in power cable (directly or through the PoE injector) to turn on the device, please see paragraph.powering
The Initial connection has to be done via the Ethernet cable, using the MikroTik Winbox utility. Winbox should be used to connect to the default IP
address of 192.168.88.1 with the username admin and no password.
We recommend clicking the "Check for updates" button and updating your RouterOS software to the latest version to ensure the best
performance and stability,
Choose your country, to apply country regulation settings (if applicable), and set up your password on the screen that loads.
* Insert the miniPCIe and M.2 cards (not included) and secure them with the included screws. [Only one 802.11 wireless card can be used at once]. It is
suggested to use the other slot for LTE modems. Please see paragraph.MiniPCIe slot usage
Assembly
M33G for professional use. Each of the devices comes in ESD protective packaging. When handling electrical equipment please observe the following
safety precautions:
Use a wrist grounding strap when unpacking and working with electrical components to avoid electrical discharge (ESD) damage.
After unpacking please place the router on the anti-static mat.
When mounting unit make sure there are no objects that can damage or touch the PCB plate.
Note that ETH, USB and other ports are extending over the perimeter of the PCB plate.
The device can be mounted in your desired location using the factory provided four holes in a PCB plate, located on each side of the device.
Mounting
The installation infrastructure (towers and masts), as well as the router itself, must be properly grounded.
Powering
The device accepts power with the following modes:
Passive 11-28 V DC PoE to J1 Ethernet port. The Higher voltage needed to compensate for power loss on long cables at least 18 V is suggested.
Direct input to the power jack DC 11-28 V.
The maximum total power consumption with all interfaces loaded is 24 W. Maximum power to each extension card is 3 A.
Connecting to a POE Adapter:
Mounting and configuration of this device should be performed by a qualified person.
To Next Page
Need help?
General
