MIMAKI JV33 Series Notes On Use

D201757-10-06092007
© 2007 MIMAKI ENGINEERING CO., LTD. Allright reserved.
Note for Roll Media Setting Procedure
Operate Step 1 of “Setting a roll media” in Operation Manual P.2-10 as follows.
Read this and fully understand the procedure, and then operate from step 2 to set a media.
• Do not push the clamp lever down while roll stopper is caught between the roll stopper arm and
this machine. The roll stopper arm might be broken and roll stopper function
*1
might be disabled.
*1： The function that once pulled out a certain amount of media, media pullout is temporarily locked.
(1) Move the roll holder to the center of this machine. (2) Check the clamp lever is lowered.
(3) Move the roll holder to the roll setting position.
(4) Check the roll stopper is not caught between the roll stopper arm and this machine.
(5) Check step (1) to (4).
ＯＫ
ＮＧ
Roll stopper arm
Roll stopper
Roll Holder side (The side of this machine)
Roll Holder
Set Position
3 Inch Roll Media
2 Inch Roll Media
Roll holder
Basis
Setting position
of 3inch tube
Setting position
of 2inch tube
Roll Holder Side (The back of this machine)
Roll Holder
Set Position
3 Inch Roll Media
2 Inch Roll Media
Set the base position
of roll holder within
this range.
IT
FW: 1.3

MIMAKI JV33 Series Specifications

General

Brand	MIMAKI
Model	JV33 Series
Category	Printer
Language	English