Important
This device requires unlocking prior to use. For all
unlocking instructions and options, prior to on-site
installation, please go to mimosa.co/start.
Power Requirements
This device accepts +/- 48VDC complying with
802.3at (PoE+), and supports all Mimosa Gigabit
PoE devices.
Included Items
C5 device, Ethernet cable gland, stainless steel
pole clamp, and silicon dielectric gel packet.
Required Items
• Any Mimosa Gigabit PoE device.
• Mimosa FlexiMount or Mimosa J-Mount for
optimal device aiming.
• Minimum 10 AWG (5.26 mm
2
) ground cable.
• Mimosa Gigabit NID.
• Phillips head screwdriver.
Extensive Instructions and Support
mimosa.co/support
C5
1. Mount
Attach the device to your preferred mount using
the included pipe clamp.
2. Ground
Attach ground wire (not
included) to integrated
grounding screw point.
Install the Mimosa
Gigabit NID at the
premises entry point
for Electrostatic Dis-
charge (ESD) protec-
tion.
To prevent device damage, avoid ground voltage
potential dierence between the device ground
and the Gigabit NID.
a
AND
b
To device
To premises
To ground
To ground
3. Connect
Push unterminated
shielded CAT6/6A Eth-
ernet cable through the
hole in the bottom of
the gland.
Apply a bead of dielec-
tric silicone to Ethernet
pins, the cable entry
area and top ridge of
the gland.
Then crimp the RJ45
connector to the cable.
Connect the Ethernet
cable and press the
gland onto the device’s
plastic retaining clips.
4. Unlock and Congure
Visit mimosa.co/start to unlock the device and
detailed conguration instructions.
Warnings, Warranty, Compliance &
Regulatory Statements
Export Control
These commodities, technology, or software were exported from the United
States in accordance with the Export Administration Regulations. Diversion
contrary to U.S. law is prohibited.
Important Safety and Handling Information
Failure to follow any of the safety instructions in this guide, instructions on any
Mimosa-provided packaging, and heed WARNINGS (indicated by ), could
result in re, electric shock, other injury or death, and incur damage to this
product or other property and void the product’s Limited Warranty.
There are no End User serviceable parts inside the equipment.
Read all operating and safety instructions contained herein and accompanying
the product as provided by Mimosa Networks, Inc. (“Mimosa”).
Electrical Safety Information
Do not operate this product in any location that can be submerged by
water.
Do not install or maintain this product during the presence of an
electrical storm to avoid risk of electric shock from lightning.
In order to comply with the Mimosa Limited Warranty conditions in this
document, you must properly ground the device according to the
a
b
included instructions. Failure to properly ground the device according to
the included instructions and use shielded CAT6/6A Ethernet cabling will
violate the product warranty and could lead to serious injury or death.
This device is a Safety Class II-compliant device including supplemental
insulation to protect against electric shock, and does not require a
connection to earth ground.
Installation of the product must comply with local and national electrical
codes.
Power specications for connected devices are indicated on the device’s
own label or documentation. Connecting to any power source that does
not meet the voltage, frequency and current requirements listed may
damage the power supply or product, and pose a re hazard.
Mandatory Grounding Instructions
IMPORTANT: In order to comply with the Mimosa Limited Warranty conditions in
this document, you must properly ground the device according to these instruc-
tions. Failure to properly ground the device will violate the product warranty.
Required Step 1- Direct Grounding on the Device:
A minimum grounding wire of 10 AWG (5.26 mm
2
) with a secured grounding
terminal, and shorter in length than 1 meter is required. It is NOT supplied with
the product.
1. Ensure that NO power is being supplied to the product.
2. Locate the Ground point screw next to the Ground icon on the device
3. Remove the provided Ground Screw
4. Thread the ground wire terminal and ground wire meeting the above speci-
cations over the screw removed in the previous step.
5. Replace and tighten the screw with the threaded ground terminal and cable
at the product Ground point.
6. Secure the other end of the grounding cable to the properly grounded struc-
ture (pole, tower, mast, etc.) meeting local and national electrical regulations
and codes.
Required Step 2 - Use Mimosa Gigabit NID for Grounding via CAT6/6A Shielded
Ethernet:
The Mimosa Gigabit NID is required to provide enhanced Electrostatic Dis-
charge (ESD) protection for devices and the premises during electrical events.
Failure to follow all instructions provided with the separately sold Mimosa
Gigabit NID will violate the product warranty and could lead to serious injury or
death.
End User Product Warranty
Products purchased from Mimosa Networks, Inc. (“Mimosa”) are warranted
against defects in material, and workmanship for a period of either (i) twelve
(12) months from the date of activation, or (ii) thirty-six (36) months from the
original date of shipment, whichever is earlier. Please go to www.mimosa.co/
warranty to determine whether your product is in warranty.
The sole responsibility of Mimosa under this warranty shall be limited to the
repair or replacement of in-warranty defective product, at Mimosa’s sole option.
Out of warranty products shipped to Mimosa will not be returned.
This warranty does not cover costs associated with the removal and/or rein-
stallation of the product for repair nor for any parts that are readily replaced in
normal use.
Mimosa or its designated partner will repair or replace product found to be
defective during the dened warranty period.
The End User is responsible for delivering defective product in accordance with
Mimosa’s Return Material Authorization (RMA) processes published at
www.mimosa.co/legal/RMA
Limitation of Warranty
Mimosa’s product warranty is invalidated if the RMA product is altered or
otherwise tampered with in a manner that modies the product from its original
shipping conguration and/or form factor, and could violate the End User’s
authority to operate the equipment, unless said activity was performed by or
with the written authorization of a Mimosa representative.
Modications include:
(a) External surfaces that have been painted, labeled, or otherwise modied
from the original shipping condition.
(b) Modications of the product with third party hardware, rmware, and/
or software.
(c) Any product subjected to abnormal physical or electric stress, including,
but not limited to, lightning strikes, negligence, accident, or misuse.
(d) Any product damaged due to incorrect installation, including, but not lim-
ited to, improper product mounting, cabling, cabling defects or connection
to power.
(e) Failure induced by connected third party products.
Improper grounding, or failure to ground the product as instructed in this guide
will void the End User warranty.
Mimosa will not warrant any product which has been installed outdoors without
the use of minimum CAT 6/6A shielded Ethernet cable and proper earth
grounding.
Disclaimer
EXCEPT FOR ANY EXPRESS WARRANTIES PROVIDED HEREIN, MIMOSA NET-
WORKS AND ITS SUBSIDIARIES, LICENSORS AND AFFILIATES ( COLLECTIVELY,
“MIMOSA”), AND ANY THIRD PARTY DATA, SERVICE, SOFTWARE AND HARDWARE
PROVIDERS MAKE NO OTHER REPRESENTATION OR WARRANTY OF ANY KIND
AND HEREBY DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, STATUTORY
OR OTHERWISE, INCLUDING, BUT NOT LIMITED TO, ANY REPRESENTATIONS OR
WARRANTIES OF DESIGN, MERCHANTABILITY, ACCURACY, QUALITY OF SERVICE
OR RESULTS, AVAILABILITY, QUIET ENJOYMENT, FITNESS FOR A PARTICULAR
PURPOSE, NON-INFRINGEMENT AND ANY WARRANTIES ARISING FROM ANY
COURSE OF DEALING, USAGE OR TRADE PRACTICE IN CONNECTION WITH SUCH
PRODUCTS AND SERVICES. YOU ACKNOWLEDGE THAT NEITHER MIMOSA NOR
ITS THIRD PARTY PROVIDERS CONTROL YOUR EQUIPMENT OR THE TRANSFER
OF DATA OVER COMMUNICATIONS FACILITIES, INCLUDING THE INTERNET,
AND THAT THE PRODUCTS AND SERVICES PROVIDED BY MIMOSA MAY BE
SUBJECT TO LIMITATIONS, INTERRUPTIONS, DELAYS, CANCELLATIONS AND
OTHER PROBLEMS INHERENT IN THE USE OF COMMUNICATIONS FACILITIES.
MIMOSA AND ANY THIRD PARTY PROVIDERS ARE NOT RESPONSIBLE FOR ANY
INTERRUPTIONS, DELAYS, CANCELLATIONS, DELIVERY FAILURES, DATA LOSS,
CONTENT CORRUPTION, PACKET LOSS, OR OTHER DAMAGE RESULTING FROM
ANY OF THE FOREGOING.
IN ADDITION, MIMOSA MAKES NO WARRANTY OR UNDERTAKING, AND MAKES
NO REPRESENTATION OF ANY KIND THAT THE LICENSED PRODUCTS WILL MEET
YOUR REQUIREMENTS, ACHIEVE ANY INTENDED RESULTS, BE COMPATIBLE
OR WORK WITH ANY OTHER APPLICATIONS, SYSTEMS OR SERVICES, OPERATE
WITHOUT INTERRUPTION, MEET ANY PERFORMANCE OR RELIABILITY STAN-
DARDS, BE ERROR FREE OR THAT ANY ERRORS OR DEFECTS CAN OR WILL BE
CORRECTED, OR THAT THE LICENSED PRODUCTS ARE NOT VULNERABLE TO
FRAUD OR UNAUTHORIZED USE.
Limitation of Liability
EXCEPT TO THE EXTENT PROHIBITED BY THE LAWS IN YOUR JURISDICTION, IN
NO EVENT WILL MIMOSA OR ITS SUPPLIERS OR LICENSORS BE LIABLE FOR SPE-
CIAL, INCIDENTAL, CONSEQUENTIAL OR OTHER DAMAGES (INCLUDING LOST
PROFIT, LOST DATA, OR DOWNTIME COSTS), NOR FOR DAMAGES BASED ON
UNAUTHORIZED USE OR ACCESS, ARISING OUT OF THE USE, INABILITY TO USE,
OR THE RESULTS OF USE OF THE PRODUCT, WHETHER BASED IN WARRANTY,
CONTRACT, TORT OR OTHER LEGAL THEORY, AND WHETHER OR NOT ADVISED
OF THE POSSIBILITY OF SUCH DAMAGES. IN NO EVENT SHALL MIMOSA, ITS
SUPPLIERS’ OR ITS LICENSORS’ DIRECT LIABILITY EXCEED THE VALUE OF THE
LICENSED PRODUCTS GIVING RISE TO SUCH LIABILITY. THESE LIMITATIONS
SHALL APPLY NOTHWITHSTANDING ANY FAILURE OF ESSENTIAL PURPOSE OF
ANY LIMITED REMEDY. IN NO EVENT SHALL MIMOSA BE RESPONSIBLE FOR
DAMAGES OR CLAIMS OF ANY NATURE OR DESCRIPTION RELATING TO NET-
WORK PERFORMANCE, INCLUDING COVERAGE, YOUR SELECTION OF MIMOSA
PRODUCTS FOR YOUR PARTICULAR APPLICATION AND/OR FAILURE OF MIMOSA
PRODUCTS TO MEET GOVERNMENT OR REGULATORY REQUIREMENTS.
Some legal jurisdictions do not allow exclusions of implied warranties or condi-
tions, or for the exclusion or limitation of liability for incidental or consequential
damages, so the above exclusion may not apply to you. You may have other
rights specic to your legal jurisdiction. EXCEPT TO THE EXTENT ALLOWED BY
THE LAW OF YOUR JURISDICTION, THESE WARRANTY TERMS DO NOT EXCLUDE,
RESTRICT OR MODIFY, AND ARE IN ADDITION TO, ANY MANDATORY STATUTORY
RIGHTS APPLICABLE TO YOU IN THE LICENSE OF ANY EMBEDDED SOFTWARE.
The United Nations Convention on Contracts for the International Sale of Goods
shall not apply to any transactions regarding the sale of the Products.
Industry Canada
This Class B digital apparatus complies with Canadian CAN ICES-3(B).
Cet appareil numérique de la classe B est conforme à la norme NMB-3(B)
Canada.
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for suc-
cessful communication.
Pour réduire le risque d’interférence aux autres utilisateurs, le type d’antenne
et son gain doivent être choisies de façon que la puissance isotrope rayonnée
équivalente (PIRE) ne dépasse pas ce qui est nécessaire pour une communica-
tion réussie.
5 GHz Integrated Client Device
To Next Page
Need help?
General