4. Slide the sealant container upright into the
holder on the compressor housing, ensur‐
ing that it engages audibly.
5. Screw the connection hose onto the tire
valve of the nonworking wheel.
6. With the compressor switched off, insert
the plug into a power socket inside the ve‐
hicle.
7. With the ignition turned on or the engine
running, switch on the compressor.
Let the compressor run for approx. 3 to 8 mi‐
nutes to fill the tire with sealant and achieve a
tire inflation pressure of approx. 2.5 bar.
While the tire is being filled with sealant, the
tire inflation pressure may sporadically reach
approx. 5 bar. Do not switch off the compressor
at this point.
CAUTION
The compressor can overheat during ex‐
tended operation. There is risk of property
damage. Do not run the compressor for more
than 10 min.◀
If a tire inflation pressure of 2 bar is not
reached:
1.
Switch off the compressor.
2. Unscrew the filling hose from the wheel.
3. Drive forward and back to distribute the
sealant in the tire.
4. Inflate the tire again using the compressor.
If a tire inflation pressure of 2 bar cannot be
reached, contact your dealer’s service cen‐
ter or another qualified service center or re‐
pair shop.
Stowing the Mobility System
1.
Remove the connection hose of the sealant
container from the wheel.
2. Remove the connection hose from the seal‐
ant container.
Seite 190
MOBILITY
Wheels and tires
190
Online Edition for Part no. 01 40 2 963 307 - VI/15
To Next Page
Loading...
Need help?
General
