The wire is long enough to guide the socket
down and through between any heat shield
that may be installed and the bumper.
4. Replace nonworking bulb.
5. To install the new bulb, proceed in reverse
order of removal.
Right fog lamp:
1.
Turn the bulb socket counterclockwise and
remove.
The wire is long enough to guide the socket
down and through between any heat shield
that may be installed and the bumper.
2. Replace nonworking bulb.
3. To install the new bulb, proceed in reverse
order of removal.
Side turn signal, bulb replacement
Follow the general instructions on lights and
bulbs, refer to page 203.
Bulbs:
▷ With orange lens: W5W
▷ With white lens: WY5W diadem
1. Open the hood. The covers of the side turn
signal lights are on the left and right next to
the hinges of the hood.
2. Loosen nuts of the cover by hand and re‐
move the cover.
3. Turn the bulb holder counterclockwise and
remove.
4. Replace the bulb.
5. To insert the new bulb, proceed in reverse
order of removal. Insert the nuts of the
cover and press down.
Seite 209
Replacing components
MOBILITY
209
Online Edition for Part no. 01 40 2 963 307 - VI/15
To Next Page
Loading...
Need help?
General
