1. PRECAUTIONS
1. Do not expose the camera to dusty, dirty or sandy conditions, if these gets into the
camera or on the lens it can damage the components.
2. Do not expose the camera to high temperatures.
The normal operating of the camera is 0℃ to 40℃ (32F to 104F).
High temperatures can shorten the life span of electronic device, and extremely high
temperature will shorten the battery and/or degrade the plastic components. Note
extreme temperatures can be achieved in parked cars in direct sunlight.
Expose the dash camera to strong sunlight when using Motion Detection mode may
cause the camera to malfunction or become damaged as the temperature can be too
high in your car in summer.
3. Do not expose the camera to a cold environment.
Extremely low temperatures can also damage the electronic components; if there is
water moisture in cold environment, freezing water can cause damage, as can thawing.
Do not try to dismantle or open the casing. Doing so may result in electrical shock and
will most likely result in damaging the camera.
4. Do not mistreat the camera, dropping, sudden impact, and vibration can cause
damage.
5. Do not clean the camera with chemicals, cleaning solution or a high concentration
detergent. Only a slightly damp cloth should be used.
6. Before using, please format the cards in the camera or computer to avoid some
unnecessary troubles; the cards also need to be formatted regularly. (see 6.36)
7. There may be a layer of plastic film on the LCD screen and the lens ,which is tended to
prevent any scratch when transportation. In the case,please remove the protective film
of lens before using, maybe you can keep the protective film on screen, it’s okay.
8. The camera use built-in supper capacity to get power from the car, due to the charge
time is a little long (about 10 seconds), first time to connect with computer, camera
maybe can’t connect with the computer or computer can’t detect a USB flash, which
are normal in the first time, please pull out the plug and re-plug USB cable to
computer, everything will go to normal.
9. Camera only start to record automatically when car engine is started . Camera can not
record when ACC power on.
To Next Page
Loading...
Need help?
General