all the files.
6.5 Loop recording
1. This camera supports automatic loop recording when the card is full. Here you can set
the segment length according to your requirement. If you need continuous video without
any segmentation, please set it to OFF but be aware that the maximum video file size is
4GB.
Video loop recording time setting see 6.21.
2. This camera also supports loop recording between card A and card B,Here you must
choose AUTO in choose card (MENU); if choose card A or card B, the videos will be not
loop recording between 2 cards, only one card is recording.
6.6 Recording Mute Video
When the camera is in either standby or recording, you can short press UP button to mute
the microphone inside camera any time; short press UP button again to cancel mute
status.
When the camera is in either standby or recording, you can long press SOS button to
mute the microphone inside camera any time; long press SOS button again to cancel
mute status.
6.7 SOS Manual Protect Video
The camera support automatic loop recording which means the oldest video will be
over-written by new video when the card is almost full unless the video is protected (read
only file attribute).
The camera can auto protect videos if the G-sensor data exceeds the configured
threshold.
You can also manually protect the videos by short press SOS button when recording;
short press SOS button again to cancel protected status.
If any impact is detected when recording, the current video will be locked automatically.
You can manually protect the video and picture in playback mode (see 6.9).
6.8 Power off Screen
When camera is standby or recording, you can short press SCREEN button to turn off the
screen to save power at any time, short press SCREEN button again to turn on the
screen.
Or you can set it in the MENU.
6.9 Videos and photos playback
1. Playback on camera
When the camera is in standby, long press DOWN button for 2 seconds to enter
videos playback; long press DOWN button again for 2 seconds to enter photos
playback; long press DOWN button thirdly for 2 seconds to standby.
When the camera is in standby, press UP and DOWN buttons to highlight the video or
photo you want to review, and then press OK to view.
To Next Page
Loading...
Need help?
General