119
OVERVIEWREPAIRS OPERATION CONTROLSDATAINDEX
FLAT TIRE – MINI MOBILITY SYSTEM*
Preparing for tire repair
Before using the MINI Mobility Sys-
tem read the warning and danger
precautions on the equipment.<
If possible, leave objects in which have
been forced into the tire.
Take off the tag regarding speed limits and
stick it onto the steering wheel.
Please remember that the liquid can-
ister must be replaced every four
years by your MINI Dealer if the equipment
has not been used.<
The instructions for using the MINI
Mobility System are also given on the
equipment.<
Pumping in liquid sealant
1. Shake the filling canister
2. Screw the filling hose onto the filling
canister
3. Unscrew the dust protection cap from
the valve of the defective tire
4. Screw out the valve core with the valve
remover. The valve remover is located in
a package with the filling hose
Place the valve core and valve
remover only on clean surfaces.<
5. Remove the cap from the filling hose
6. Push the filling hose onto the tire valve
7. Hold the filling canister with the cap
down and squeeze.
Squeeze the entire contents of the canis-
ter into the tire
8. Remove filling hose
9. Screw valve core into the tire valve with
the valve remover.
In the event of a dirty valve core or of
losing it you will find another valve
core in a package with the filling hose.<
ba.book Seite 119 Montag, 5. August 2002 8:09 20
Online Edition for Part-No. 01 41 0 156 890 - © 09/02 BMW AG
To Next Page
Loading...
Need help?
General
