GENERAL INFORMATION 11A-0-3
...........................................
1. SPECIFICATIONS 11A-1-1
.................................................
SERVICE SPECIFICATIONS 11A-1-1
....................................
REWORK DIMENSIONS 11A-1-3
........................................
TORQUE SPECIFICATIONS 11A-1-4
.....................................
NEW TIGHTENING METHOD-BY USE OF BOLTS TO BE
TIGHTENED IN PLASTIC AREA 11A-1-6
................................
SEALANT 11A-1-6
........................................................
FORM-IN-PLACE GASKET 11A-1-7
......................................
2. SPECIAL TOOLS 11A-2-1
.................................................
3. ALTERNATOR AND IGNITION SYSTEM 11A-3-1
........................
4. TIMING BELT 11A-4-1
......................................................
5. FUEL AND EMISSION CONTROL SYSTEMS 11A-5-1
...................
5a. INTAKE MANIFOLD AND THROTTLE BODY (GDI) 11A-5a-1
.........
5b. EXHAUST MANIFOLD (GDI) 11A-5b-1
.................................
6. WATER PUMP AND WATER HOSE 11A-6-1
.............................
7. INTAKE AND EXHAUST MANIFOLDS 11A-7-1
..........................
7a. FUEL SYSTEM (GDI) 11A-7a-1
.........................................
8. ROCKER ARMS AND CAMSHAFTS 11A-8-1
............................
8a. ROCKER ARMS AND CAMSHAFTS (GDI) 11A-8a-1
..................
9. CYLINDER HEAD AND VALVES 11A-9-1
.................................
10. OIL PUMP AND OIL PAN 11A-10-1
.......................................
11. PISTONS AND CONNECTING RODS 11A-11-1
..........................
12. CRANKSHAFT AND CYLINDER BLOCK 11A-12-1
.....................
11A-0-1
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
ENGINE
4G1 SERIES
CONTENTS
PWEE9520-D
E
Aug. 2000Mitsubishi Motors Corporation Revised
To Next Page
Need help?
General
