Moman H2 User Manual

Installation Installation
Specications
Notes
1. Method 1: Install with Back Clip
Method 2: Install with Velcro Clip 2. How to Remove the Intercom from Helmet
3. How to Fix the Headset Plug (If necessary)
① Use the screwdriver to loosen the screws of the back clip so that it can open
to a proper extent.
② Open the helmet liner, insert the clip into the right position on the left side of
the helmet and tighten the screw.
③ Slide the intercom into the back clip slot to make sure it locks firmly.
④ Open the helmet liner (ear position), clean the EPS surface of the helmet,
and stick a piece of horn Velcro on the left and right sides of the helmet.
⑤ Stick the speaker on the fixed Velcro surface and the speaker with short line
should be installed close to the machine. Fix the microphone and arrange the
helmet lining and cable.
⑥ Insert the headset into the jack of the intercom and tie up the headset cable.
Separate the hook and loop fasteners. First stick the hook onto the Velcro
clip; choose the right installation position on the helmet and stick the loop to
the position. Install the intercom onto the Velcro clip.
The installation of speakers can refer to the description above.
First unplug the headset, then press the xed buckle in the middle of the
back clip with one nger (push towards the side of the helmet), so that
the back clip hook is detached from the intercom, and push the intercom
upwards to let it slide out of the back clip smoothly to complete the
disassembly.
Unscrew the screws on the back of intercom with
screwdriver, open the buckle ap, plug in the headset
plug and tighten the screws. If you need to plug
out the headset, please open the buckle ap by
unscrewing the screws.
1. Before using the Bluetooth intercom, please use the attached charging
cable to charge the intercom. The small type-C interface on the charging
line is connected to the USB charging interface of the Bluetooth intercom,
and the large USB connector on the charging cable is connected to the
following charging interface for power supply:
A. USB interface of computer;
B. A mobile power supply with DC 5V output;
C. A USB power adapter with DC 5V output.
2. When charging, the red LED is always on, and when fully charged, the red
light goes out slowly. It takes up to 2.5 hours to fully charge the unit.
1. If you do not use intercom for up to one month or more, please charge
the intercom once every two months in order to protect the lithium battery;
2. The storage temperature of this product is -20 ℃ to 50 ℃ , and do not
store in the environment with too high or low temperature, otherwise, the
service life of the product will be aected;
3. Do not expose this product to re to avoid explosion;
4. Only two screws on the back of intercom can be opened. Do not open
other screws to the intercom to avoid short circuit of main board or battery
damage.
Transmission Range
Connection Distance with Mobile
Bluetooth Version
Bluetooth Protocol
Charging Port
Standby Time
Working Time
Battery
Charging Time
Charging Voltage
Speaker Diameter
Frequency Range
Temperature Range
up to 800m
20m
5.0
A2DP, AVRCP
Type-C
300H
20H
900mA
2H
5V
40mm
2.4GHz
-20~50
℃
Unit 25 Basepoint Business Centre, Aviation Park, West Christchurch, United
Kingdom BH23 6NX
www.momanx.com
@MomanGlobal
https://moman.co/youtube
Moman (UK) Limited

Moman H2 Specifications

General

Brand	Moman
Model	H2
Category	Headsets
Language	English