23
Getting Started
Charging the Battery
New batteries are shipped partially charged. Before you can
use your phone, you need to install and charge the battery as
described below. Some batteries perform best after several
full charge/discharge cycles.
1
Open the protective cover and plug
the travel charger into the USB
connector port on your phone as
shown.
2
Plug the other end of the travel
charger into the appropriate
electrical outlet.
Note:
It may take up to 10 seconds for your phone to
provide a visible or audible indication that the battery is
charging.
3
When the battery level indicator in the display stops
blinking and shows that the battery is fully charged,
remove the travel charger.
Tip:
You can safely leave the travel charger connected to the
phone after charging is complete. This will
not
damage the
battery.
To Next Page
Loading...
Need help?
General
