Your radio can also be configured to allow you to accept or reject an upgrade.
7.26.1
Responding to the Notification of Upgrade
Procedure:
1 The display shows Upgrade? and two short, medium- pitched tones sound every 30 seconds
until the user makes a choice of either accepting, delaying, or rejecting the request.
NOTE: Do not remove the power cable or power down the radio during the firmware
upgrade process.
2 Perform one of the following actions:
• Press the Menu Select button below Acpt to accept the request to upgrade immediately.
• Press the Menu Select button below Dlay to delay the request to upgrade.
• Press the Menu Select button below Rej to reject the request to upgrade.
One of the following scenarios occurs:
• If you choose to accept, the display shows Programming Dont power off to indicate that the
upgrade is about to begin. The radio resets to install the upgrade. In the case of configuration data
upgrade, the process only takes a few seconds. In the case of firmware upgrade, the installation
takes several minutes.
NOTE: The radio cannot be used while the upgrade is being installed. Therefore, make sure
to only accept the upgrade at a convenient time when immediate radio use is not required.
• If you choose to delay, a configuration data upgrade is installed automatically at the next power up.
However, in the case of a firmware upgrade, the radio prompts Upgrade? again at the next power
up.
• If you choose to reject, the display shows Upg Aborted. The radio continues to function with the
current configuration until it gets reprogrammed.
NOTE: If your radio has problems upgrading over-the-air, consult a qualified technician for
details.
7.27
Voice Announcement
This feature enables the radio to audibly indicate the current feature mode, zone, or channel assigned
to the user.
The available voice announcement (VA) priority options are:
High
Voice announcement is enabled even when the radio is receiving calls.
Low
Voice announcement is disabled when the radio is receiving calls.
NOTE: If the Voice Announcement field is set to Enabled, after an interruption by a
momentary tone one of the following scenarios occurs:
• If Suppress Replay field is Enabled, voice announcement replays.
• If Suppress Replay field is Disabled, voice announcement turns off.
MN001425A01-AW
Chapter 7 : Advanced Features
123
To Next Page
Loading...
Need help?
General
