hone
4. Test and Use
1. Charge Bluetooth Battery for 2 Hours
A. Plug AC power charge into the end of bleutooth
The bluetooth indicator light turns on when the battery is charging
It may take up to 1 minute for the light to turn on.
When full charged (about 2 hours), the light will turns off.
B. Unplug the AC power adaptor
Note: Bluetooth is not funtional while charging. Charge from PC is applicable.
2. Start Bleutooth Feature on Your Phone
Your cellphone's Bluetooth feature is off by default. To use bluetooth neckloop, turn on the Bluetooth feature.
For most Motorola cell phones:
A. Select Menu > Settings > Connections > Bluetooth Link > Setup.
B. Scroll to Power
C. Press Change
D. Scroll to On
E. Press Select to turn on the Bluetooth feature. Bluetooth feature remains on unitl you turn it off.
Note: These steps are for most Motorola cell phones. For other phones, see your phone's user's guide.
3. Pair Bluetooth and Cellphone
Before use neckloop, must pair it with your phone.
A. Put Bluetooth in paring mode
i. With the bluetooth power off, press and hold the call button for 6 to 10 seconds until the blue indicator light
turns on and remains steadily it. (The light will flash while you hold the call button)
ii. If the indicator light is flashing or does not remain steadily lit, turn off the bleutooth and repeat step i.
B. The phone to look for bluetooth (for most Motorola phones:)
i. Select Menu > Settings > Connection > Bluetooth Link > Handsfree > Look for Devices.
The phone lists all Bluetooth devices it finds.
ii. Select Motorola H500.
iii. Press OK or Yes to pair the bluetooth.
iv. Enter the password 0000 and press OK.
While bluetooth is successfully paired with your phone, the indicator changes from steadily lit to flashing.
Note: These steps are for most Motorola cell phones. For other phones, see your phone's user's guide.
Ph
To Next Page
Need help?
General
