OnChip SATA Controller
This item allows users to enable or disable the SATA controller.
RAID Mode
This item is used to select mode for SATA connectors.
I/O Devices
Press <Enter> to enter the sub-menu and the following screen appears:
COM Port 1/ 2
Select an address and corresponding interrupt for the serial port.
Parallel Port
There is a built-in parallel port on the on-board Super I/O chipset that provides Stan-
dard, ECP, and EPP features. It has the following options:
[Disabled]
[3BC] Line Printer port 0
[278] Line Printer port 2
[378] Line Printer port 1
Parallel Port Mode
[Normal] Standard Parallel Port
[EPP] Enhanced Parallel Port
[ECP] Extended Capability Port
[ECP + EPP] Extended Capability Port + Enhanced Parallel Port
[Bi-Directional]
To operate the onboard parallel port as Standard Parallel Port only, choose [Nor-
mal]. To operate the onboard parallel port in the EPP mode simultaneously, choose
[EPP]. By choosing [ECP], the onboard parallel port will operate in ECP mode only.
Choosing [ECP + EPP] will allow the onboard parallel port to support both the ECP
and EPP modes simultaneously.
▶
▶
▶
▶
▶
▶
To Next Page
Loading...
Need help?
General
