To Next Page

To Previous Page

MTX.COM

Step 4 - Prepare the speaker pod by removing the four (4) T15 screws holding the speaker in place

Step 5 - Disconnect the speaker wire connections and set the speakers aside.

Step 6 - The speaker pods mount to the vehicle through the two (2) holes in the back of the enclosure

aligning with pre-molded bosses found on the back wall of the storage shelf. Left and right pods are

identiedbyensuringtheMTXlogoonthebackisrightsideup.

Questions and Answers:

Need help?

Do you have a question about the MTX RNGRPOD65 and is the answer not in the manual?

MTX RNGRPOD65 Specifications

General