indicated by a red LED.
Rate Resolution Channels Buffer time
32kHz 16-bit stereo 1s
32kHz 16-bit mono 2s
16kHz 8-bit µ-law stereo 4s
16kHz 8-bit µ-law mono 8s
Changing audio quality erases the audio buffer.
Beyond granularization...
Setting the DENSITY and TEXTURE knobs to their ex-
tremes activates variations of the granular processing al-
gorithm. Grain position, size, and rate are then optimized
to generate a continuous stream of sound.
Blending modes
Press the Blending mode/Audio quality button re-
peatedly to select one of the four blending modes. The
current mode is indicated by a green LED.
Dry/wet balance
The BLEND knob and its CV input control the balance
between the original signal and the granularized signal.
Crossfade/rotation
The BLEND knob and its CV input progressively swap the
position of the left and right channels. The L output will
thus crossfade from L to R, and the R output from R to L.
Feedback
The BLEND knob and its CV input control the amount of
output signal reinjected back into the input of the mod-
ule. This mode is capable of very abrasive tones!
Reverb
The BLEND knob and its CV input control the amount of
digital reverberation applied to the output signal.
Audio quality
Hold the Blending mode/Audio quality button for
one second, then press it repeatedly to select the
recording quality. The current quality setting is
Clouds
Texture synthesizer
Saving and loading buffers
Up to 4 frozen audio buffers can be saved and reloaded.
Saving
1. Hold the Load/Save button for one second.
2. Press the Blending mode/Audio quality button
repeatedly to select one of the 4 memory slots. The
selected slot is indicated by a blinking red LED.
3. Press the Load/Save button to confi rm.
Loading
1. Press the Load/Save button.
2. Press the Blending mode/Audio quality button
repeatedly to select one of the 4 memory slots. The
selected slot is indicated by a blinking green LED.
3. Press the Load/Save button to confi rm.
If you press the Load/Save button by mistake, do not
press any button for a few seconds and the module will
return to its normal state.
microlooper/scratcher
pitchshifter/timestretcher
microlooper with diffusion
pitchshifter/timestretcher
with diffusion
To Next Page
Need help?
General
