About Marbles
Marbles is all about randomness – generation of random
events, or randomization of external CV/Gate signals. The
module is organized as three sections: the t section gen-
erates and processes clocks and triggers, the X section
generates and processes voltages, and the DEJA VU section
imposes structure, in the form of repetition, upon all the
events generated by the two other sections.
Installation
Marbles requires a -12V/+12V power supply (2x5 pin con-
nector). The red stripe of the ribbon cable (-12V side) must
be oriented on the same side as the “Red stripe” marking on
the module and on your power distribution board.
The module draws 80mA from the +12V rail, and 20mA from
the -12V rail.
Online manual and help
The full manual can be found online at
mutable-instruments.net/modules/marbles/manual
For help and discussions, head to
mutable-instruments.net/forum
Please refer to the online manual for detailed infor-
mation regarding compliance with EMC directives
To Next Page
Need help?
General