To Next PageTo Next Page
Need help?Do you have a question about the mycom i160M and is the answer not in the manual?
General| Brand | mycom |
|---|---|
| Model | i160M |
| Category | Air Compressor |
| Language | English |
Highlights critical safety measures and precautions for operating the product.
Details essential rules and prohibitions for safe operation and maintenance.
Identifies potential hazards and outlines countermeasures for safe operation.
Explains the use of circuit breakers with lockout/tagout for safety.
Describes various protective devices for compressor safety and their settings.
Presents detailed technical specifications for the i-Series compressors.
Lists the standard technical data and parameters for the i-Series compressors.
Defines the permissible operating ranges for speed, pressure, and temperature.
Specifies alarm and stop set values for compressor protection.
Provides essential safety and procedural guidelines before starting installation.
Details the step-by-step procedures for installing the compressor package unit.
Procedures and safety precautions for safely transporting the compressor.
Details on lubricating oil properties, selection, and management.
Guidelines for choosing the correct lubricating oil based on system requirements.
Lists specific oil brands and types recommended for different refrigerants.
Important considerations for safe and efficient compressor operation.
How to prevent liquid refrigerant from returning to the compressor.
General safety and procedural guidelines before performing maintenance.
Lists items and intervals for regular maintenance and inspection tasks.
Scheduled inspection tasks to be performed at regular intervals.
Prepares for compressor disassembly, covering tools and parts.
Lists standard replacement parts for overhauled i-series compressors.
Procedures for handling refrigerant gas during disassembly.
Methods for recovering refrigerant gas safely before disassembly.
Guidance on safely removing and lifting the compressor unit.
Detailed steps for disassembling compressor parts and inspecting them.
Procedure for disassembling and inspecting the shaft seal assembly.
Disassembly and inspection of the thrust bearing assembly.
Disassembly and inspection of the compressor rotors, critical components.
Checks for rotor wear and damage, with replacement standards.
Disassembly and inspection of the suction strainer and check valve.
General procedures and precautions for reassembling the compressor.
Procedure for installing radial bearing inner races onto rotors and assembling rotors.
Reassembly of the suction strainer and check valve components.
Procedure for adjusting the thrust bearing and end clearance.
Methods for adjusting end clearance if it falls outside specifications.
Detailed procedure for reassembling the shaft seal block.
Troubleshooting steps for when the compressor fails to start.
Diagnosing why the compressor stops shortly after startup.
Identifying causes and solutions for low suction pressure.
Troubleshooting low oil supply pressure issues.
Addressing abnormally high discharge pressure problems.
Resolving issues with abnormally high discharge temperatures.
Diagnosing and fixing leaks from the mechanical seal.
