NAPCO GEMINI C Series User Manual

NAPCO Security Group
NAPCO Gemini C-Series Control Panel Programming Instructions--Volume 2
Page 72 Programming Instructions, Volume 2
DIRECT ADDRESS OVERVIEW
Direct Address Programming allows you to go directly to the address locations (up to 8179) and change the data entries
manually in order to customize your control panel options. Whereas the Easy Menu Program Mode guides you through
limited selections to get you started, Direct Address Program Mode allows you to change all options directly. It con-
sists of up to 8179 address locations each with data entry locations as shown in the following diagram (below left). The
data entry location accepts data in one of three formats: Binary, Decimal and Hexadecimal (explained below in
"Address Mode Displays"). The following diagram (below right) illustrates a Decimal format data entry location (using
a GEMC-FK1 Fire keypad). Note: PCD-Windows MUST be used to place the Gemini C-Series system into operation.
ADDRESS MODE DISPLAY S
There are three types of address displays when programming in Direct Entry Program Mode, as follows:
A) BINARY (BIT) FORMAT
Settings (such as Zone Features) display and accept data in binary "bit" or "number" format. For example, Zone
Features are turned on by the pressing of keypad buttons 1 through 8, with the activated Zone(s) displaying the cor-
responding decimal digit (replacing deactivated zones which are signified by dashes).
EXAMPLE: With the GEMC-FK1 Fire keypad: Program Zones 2, 4, 5 and 7 as Exit/Entry Follower Zones.
DETERMINE THE DATA ENTRIES
Referring to the ZONE FEATURES page in the programming worksheets that follow, "Exit/Entry Follower" for zones
1 through 8 are located at address 2018.
DATA ENTRY
LOCATION
ADDRESS
LOCATIONS
0000
0000
TO
8179
DATA ENTRY LOCATION:
(One of three formats):
• Binary (Bit)
• Decimal
• Hexadecimal
DIRECT ADDRESS PROGRAM MODE (CONT'D)
GEMC-FK1 Keypad Display Example
0 0 0 0 0 6 0 D
1 2
= ADDRESS LOCATION
1
2
= DATA ENTRY LOCATION
2018 - - - - - - - - B 2018 - 2 - 4 5 - 7 - B
Address
2018
"Exit/Entry
Follower"
Address
2018
"Exit/Entry
Follower"
DATA ENTRY LOCATION:
Binary (Bit) Format
Press 2 4 5 and 7 in order
to activate Zones 2, 4, 5, and 7. (The "B" on the
right indicates "Binary" format).
DATA ENTRY LOCATION:
Binary (Bit) Format
• No zones yet activated

NAPCO GEMINI C Series Specifications

General

Brand	NAPCO
Model	GEMINI C Series
Category	Control Panel
Language	English