THIS MANUAL INCLUDES FEATURES WHICH ARE ONLY AVAILABLE IN CONTROL PANEL
FIRMWARE VERSION 90.69 OR GREATER, AND REFLECTS THE FEATURES FOUND IN
PCD-WINDOWS QUICKLOADER DOWNLOAD SOFTWARE VERSION 6.4.8 OR GREATER.
NAPCO Security Technologies, Inc.,
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
http://www.napcosecurity.com
Warning: The use of non-NAPCO wireless devices with this control panel has not been evaluated by UL and voids
the UL listing. In addition, the performance of these devices can not be guaranteed as compatible with NAPCO
control panels. For systems that include CO detectors, the system must be monitored by a central station.
IMPORTANT NOTE
The Gemini C-Series combination Fire and Burglary control panels are normally programmed with the GEMC-FK1
Fire keypad. However, the control panel can also operate as a "Burglary Only" panel (following the procedure de-
tailed in the section "BASIC OPERATION, Burg-Only Systems"), and may be programmed with the GEMC-BK1
keypad. In programming mode, the key locations used to program with the
GEMC-BK1 keypad are identical to the GEMC-FK1 keypad, however only
the button labels are different. Compare the images of the two keypads on
the cover of this volume. Note that the GEMC-FK1 keypad buttons "NEXT",
"PRIOR", "ACK." and "SILENCE" are labeled "INTERIOR", "INSTANT",
"G", and "BYPASS" on the GEMC-BK1 Burglary keypad, respectively.
These button equivalents are also expressed in the table at right:
GEMC-FK1 GEMC-BK1
NEXT INTERIOR
PRIOR INSTANT
ACK.
G
SILENCE BYPASS
To Next Page
Loading...
Need help?
General
