Neato Robotics D9 Important Information Manual

ENGLISH
This device complies with Industry Canada’s license-exempt RSSs.
Operation is subject to the following two conditions: (1) This device may
not cause interference; and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
Laser
The Navigation Sensor contains a Class 1 rotating laser per
IEC/EN 60825-1 during all procedures of operation.
• Do not aim the laser at other persons.
• Do not look at the direct or reflected beam.
• Always switch the robot vacuum o during changeover tasks.
• Modifications (changes) or attempts to repair the robot vacuum
cleaner or the navigation sensor are strictly prohibited and may
result in hazardous radiation exposure.
End User License Agreement, Trademarks and Copyright
The Neato Robotics, Inc. End User License Agreement is available online
at NeatoRobotics.com. NEATO ROBOTICS, NEATO, NEATO INTELLIGENT
ROBOT VACUUM are registered trademarks of Neato Robotics, Inc.
Other trademarks, trade names and service marks are the registered and
unregistered trademarks, trade names and service mark of their
respective owners.
Disposal
Disposal of the Product
This symbol on product indicates the product must not be disposed
of with other household refuse. It must be disposed of and collected
for recycling and recovery of waste EEE. For more information about
where you should dispose of your waste equipment for recycling and
recovery please contact your dealer or distributor from which your
product was purchased.
Disposal of batteries
This symbol on the battery indicates the battery must not be disposed
of with other household refuse. It must be disposed of and collected for
recycling and recovery through your local free battery collection system.
For more information about where you should dispose of your battery
for recycling and recovery please contact your dealer or distributor from
which your product was purchased.
Remove the battery from the product before disposal and dispose
seperately in accordance with local regulations.
Technical Data
Robot Vacuum
Input Voltage: 19.5V, 29.25 W, 1.5A
Charge Base
Input Voltage: 100-240V ~ 50-60Hz, 1.0A
Output Voltage: 19.5V == 29.25W, 1.5A
Limited Manufacturer’s Warranty Summary
Neato Robotics, Inc. warrants to the original purchaser (“you” or “your”)
that your Neato hardware product (“Product”), excluding batteries and
other consumables, shall be free from defects in material and workmanship
for 1 year from the original date of purchase. In the case of batteries, a
Warranty Period of six (6) months shall apply and ‘Warranty Period’ shall
be read accordingly throughout this document. In the case that the product
purchased is a Neato-Certified Refurbished product, a Warranty Period of
three (3) months shall apply and ‘Warranty Period’ shall be read accordingly
throughout this document. In the absence of proof of purchase, Neato
Robotics will take the date of manufacture plus 90 days to allow for transit
and sale as the date of purchase.
This warranty is void if parts other than Neato Genuine replacement parts
are used including but not limited to batteries, filters, brushes and boundary
markers. Using unauthorized, apparently compatible items available on the
market may damage your product or create an unsafe situation.
You may also find the full details of this limited warranty by selecting your
Product in the Support section of our website at NeatoRobotics.com.
Except where prohibited by applicable law, this warranty is nontransferable
and is limited to the original purchaser and applies only to products
purchased and used in the same country. This warranty gives you specific
legal rights, and you may also have other rights that vary under local laws.
If you are dealing as a consumer this limited warranty does not aect your
statutory rights.
Support. Visit NeatoRobotics.com for the detailed Manufacturer’s
Limited Warranty and for details on how to obtain support, purchase
replacement consumables.
March 1, 2020
CLASS 1 LASER PRODUCT

Neato Robotics D9 Specifications

General

Shape	D-shape
Product color	Black
Dust container type	Dust bag
Brush type	Roller brush & Side brush
HEPA class	HEPA 11
Noise level	- dB
Wet mopping	No
Number of brushes	2
Integrated sensors	Drop sensor
Programming function	Yes
Vacuum air filtering	HEPA
Dust capacity (total)	0.7 L
Base station functions	Charging
Vacuum cleaner programs	Turbo
Floor surfaces supported	Carpet, Hard floor, Laminate, Linoleum, Parquet, Tiles, Wood
Battery capacity	4200 mAh
Package type	Box
Package width	450 mm
Package height	160 mm
Package weight	5500 g

Weight and Dimensions

Depth	100 mm
Width	340 mm
Height	330 mm
Weight	3700 g