English-11
English
Terminal Panel
USB Upstream
A AC IN Connector
Connects with the supplied power cord.
B Main Power Switch
On/Off switch to turn main power ON/OFF.
C Audio IN
Audio signal input from external equipment such as a
computer or player.
D DisplayPort OUT
Output DisplayPort signals from DisplayPort IN1.
You can connect multiple monitors by using DisplayPort
daisy-chain connection. See MULTI DISPLAY (page 39) and
Video out (page 68).
E DisplayPort IN1/IN2
DisplayPort signals input.
F HDMI IN1/IN2/IN3
Digital HDMI signals input.
G RS-232C IN (D-Sub 9 pin)
Connect RS-232C input from external equipment, such as a
computer, in order to control RS-232C functions.
H Remote IN
Use the optional sensor unit by connecting it to your monitor.
NOTE: Do not use this connector unless specified.
I microSD Card Slot
microSD memory card reader for use with the Media Player
(See page 23).
To install the microSD card slot cover, please refer to
“Installing microSD card slot cover” (See page 23).
J USB Port
USB1: Downstream port (USB Type-A).
Connect USB devices.
USB2: Upstream port (USB Type-B).
Connect external equipment such as a
computer.
To control the monitor from connected external
equipment, please use this port.
USB CM1 (2A): Power supply port.
USB CM2*: Service port. Please do not connect devices.
* USB functionality is available when the optional Raspberry
Pi Compute Module Interface Board and Raspberry Pi
Compute Module are installed.
USB MP: USB storage device reader for use with the
Media Player. See page 22. This port is for
future software upgrades.
To use the Media Player, please connect USB
storage device to this port (See page 19).
MP is an abbreviation of Media Player.
K LAN Port 1/2 (RJ-45)
Connect to LAN in order to manage and control the monitor
over the network. See page 48 and page 51.
NOTE: Please give priority for use to LAN1.
L Audio OUT
Audio signal output from the AUDIO IN, DisplayPort and
HDMI to an external device (stereo receiver, amplifier, etc.).
NOTE: This connector is not a Headphone terminal.
M Internal/External Speaker Switch
: Internal speaker : External speaker.
NOTE: Please turn off the monitor’s main power when you
use the Internal/External speaker switch.
N External Speaker Terminal
Audio signal output.
Red terminal is plus (+).
Black terminal is minus (-).
NOTE: This speaker terminal is for 15 W + 15 W (8 ohm)
speaker.
O Internal Speaker
To Next Page
Loading...
Need help?
General