English-11
English
Mount Flexible Arm
This LCD monitor is designed for use with a fl exible arm.
1. Follow the instructions on how Remove Monitor Stand for Mounting to remove the stand.
2. Use the 4 screws removed from the stand or the specifi ed screws to attach the arm to the monitor (Figure F.1).
Caution: Use ONLY the screws (4 pcs) that were removed from the stand or the specifi ed screws (Figure F.1) to avoid
damage to the monitor or stand.
To meet the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability
under consideration of the weight of the monitor. The LCD monitor should only be used with an approved arm
(e.g. TUEV GS mark).
NOTE: Tighten all screws (recommended Fasten Force: 98 - 137N•cm).
Thickness of Bracket (Arm)
2.0~3.2 mm
Spring washer
Flat washer
Weight of LCD assembly: 2.9 kg (E203Wi)
3.7 kg (E233WM)
100 mm
100 mm
Figure F.1
12 mm
Attaching VESA Plate for Thin Client Computer*
This LCD monitor is designed for mounting a thin client computer by
using VESA plate and screws.
Make sure to attach the VESA plate by tightening all included screws.
For mounting a thin client computer, please refer to the computer’s
manual.
NOTE: Make sure the monitor does not fall after attaching a thin
client computer.
Do not mount a fl exible arm on the VESA plate.
Please make sure a thin client computer does not cover
ventilation holes on the monitor.
Mounting on a thin client computer is the customer’s
responsibility.
* Depending on the where the monitor is to be shipped.
VESA plate
Screws
To Next Page
Loading...
Need help?
General