EasyManuals Logo
Home>NEC>Monitor>MultiSync E233WM

NEC MultiSync E233WM User Manual

NEC MultiSync E233WM
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
English-7
English
Figure C.1
* E233WM only.
Power cord
20° Tilt
DisplayPort DVI
D-SUB
Highest
Stand
Position
Audio Input*
Audio Input*
Headphone*
To connect the LCD monitor to your system, follow these instructions:
NOTE: Make sure to read “Recommended Use” (page 4) before installation.
The accessories included will depend on the where the LCD monitor is to be shipped.
1. Turn off the power of your computer.
2. For a PC with DisplayPort output: Connect the DisplayPort cable to the connector of the display card in your system
(Figure A.1).
For a PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your system
(Figure A.2). Tighten all screws.
For a PC with Analog output: Connect a 15-pin mini D-SUB signal cable to the connector of the display card in your
system (Figure A.3).
For a MAC with Thunderbolt output: Connect a Mini DisplayPort to DisplayPort adapter to the computer and then attach
the DisplayPort cable to the adapter and to the display (Figure A.4).
Figure A.1
Figure A.3
Figure A.2
Figure A.4
DisplayPort cable DVI cable
Macintosh Cable Adapter
Macintosh Cable Adapter
NOTE: 1. When removing the DisplayPort cable, hold down the top button to release the lock.
2. Please use a DisplayPort Certifi ed DisplayPort cable.
3. Place hands on each side of the monitor to tilt the LCD panel 20-degree angle and lift up
to the highest position.
4. Connect all cables to the appropriate connectors (Figure C.1).
NOTE: Incorrect cable connections may cause abnormal operation, damage display
quality/components of LCD module and/or shorten the module’s life.
Use an audio cable without a built-in resistor. Using an audio cable with
a built-in resistor turns down the sound*.
CAUTION: To raise or lower screen, place a hand on each
side of the monitor and lift or lower to the desired
height. When you use handle to lower screen,
you might pinch your fi ngers.
NOTE: Adjustment of the volume control as well as
the equalizer to other settings than the center
position may increase the ear-/headphones
output voltage and therefore the sound
pressure level.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC MultiSync E233WM and is the answer not in the manual?

NEC MultiSync E233WM Specifications

General IconGeneral
BrandNEC
ModelMultiSync E233WM
CategoryMonitor
LanguageEnglish

Related product manuals