English
English-11
Specifications for MultiSync LCD175VXM+
Monitor Specifications MultiSync LCD175VXM+ Monitor Notes
LCD Module Diagonal: 43 cm/17 inches Active matrix; thin film transistor (TFT)
Viewable Image Size: 43 cm/17 inches liquid crystal display (LCD); 0.264 mm dot
Native Resolution (Pixel Count): 1280 x 1024 pitch; 300 cd/m
2
*
2
white luminance, 700:1
contrast ratio, typical; response time: 5 ms.
Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Digital Input: DVI-D
Sync: Separate sync.TTL Level (Positive/Negative)
Horizontal sync. Positive/Negative
Vertical sync. Positive/Negative
Display Colours Analog input: 16,7 M Depends on display card used.
Synchronization Range Horizontal: 31.5 kHz to 81.1 kHz Automatically
Vertical: 56 Hz to 76 Hz Automatically
Viewing Angle Left/Right: -80°/+80° (CR>10), -88°/+88° (CR>5)
Up/Down: -75°/+85° (CR>10), -85°/+85° (CR>5)
Resolutions Supported Landscape: 720 x 400*
1
: VGA Some systems may not
640 x 480*
1
@ 60 Hz to 75 Hz support all modes listed.
800 x 600*
1
@ 56 Hz to 75 Hz
832 x 624*
1
@ 75 Hz
1024 x 768*
1
@ 60 Hz to 75 Hz
1152 x 864*
1
@ 70 Hz to 75 Hz
1152 x 870*
1
@ 75 Hz
1280 x 960*
1
@ 60 Hz to 75 Hz Recommended resolution is 60 Hz for
1280 x 1024 @ 60 Hz to 75 Hz................... optimal display performance.
Active Display Area Horizontal: 337.9 mm
Vertical: 270.3 mm
Speakers Practical Audio Output: 1.0 W + 1.0 W
Power Supply 100 - 240 V ~ 50/60 Hz
Power Consumption 34 W
Dimensions Landscape: 368.0 mm (W) x 358.5 - 408.5 mm (H) x 230.0 mm (D) (with stand)
368.0 mm (W) x 320.5 mm (H) x 61.0 mm (D) (without stand)
Weight with stand: 4.8 kg
without stand: 3.8 kg
Environmental Considerations
Operating Temperature: 5 °C to 35 °C
Humidity: 30% to 80%
Altitude: 0 to 3,048 m
Storage Temperature: -10 °C to +60 °C
Humidity: 10% to 85%
Altitude: 0 to 12,192 m
*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is
normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot on
the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.
*2 LCD Module at 25°C.
NOTE: Technical specifications are subject to change without notice.
To Next Page
Loading...
Need help?
General