GET STARTED
TM
1. Connect one end of the RJ-45 Ethernet cable to one of the LAN ports and the other end to
your computer. Skip to Step 3 if you have Naked ADSL2+
2. If you have Traditional ADSL/ADSL2+ - connect the Plain Old Telephone Service (POTS)
pass-through line:
• Connect the telephone wall socket to the Line port on the in-line splitter.
• Connect one end of an RJ11 (telephone) cable to the Phone port of the in-line splitter
and the other end to the DSL port on the modem.
3. Connect one end of the RJ-11 (telephone) cable to the DSL port on the back of the modem
router and the other end to the ADSL wall socket.
4. Connect the power adaptor to your modem router and press the power button to turn the
modem router on.
For wireless setup, please refer to Page 2
1
Connecting Your Modem – Netcomm NB604N
If you got your modem from MyNetFone, then all you need to do is plug it in by following the
steps below:
Wireless Antennas
ADSL Line In Factory
Reset
Button
Up to 4
Computers
12V DC 1.5A
Power Supply
USB Port for
external
hard drive
Power
Button
To Next Page
Need help?
General
