EasyManuals Logo
Home>NetComm>Gateway>NF18ACV

NetComm NF18ACV Connection Guide

NetComm NF18ACV
3 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
33Page
FW guide
www.barefoottelecom.com.au 1300 017 622 support@barefoottelecom.com.au
for each dierent modem. If you get stuck or it is
not clear where you should change your Internet
settings, you need to check the manufacturer’s
website for support information. Ideally, your
modem will have a Setup Wizard or Quick Setup
that will run automatically the first time you log in to
the settings, or there’ll be a fairly obvious button to
launch it.
6. The Setup Wizard should run you through
entering the required broadband settings, step by
step. The most important settings are the following:
• Encapsulation or Connection Type
• Must be set to PPPoE
• Connection Mode/Access Type/Service Type
• Must be set to ETHERNET WAN/RESIDENTIAL
GATEWAY/WIRELESS ROUTER MODE
This will then allow you to enter your username
(sometimes called Login) and password which are
supplied in your Barefoot Welcome Letter email.
7. After completing the Setup Wizard and saving
your settings, give the modem some time. Some
modem routers reboot automatically after every
new configuration, while others simply need a
few minutes to apply the settings. Take a look
at the lights on your modem router. Most should
now be green, blue, purple or another “positive”
colour. Many modem routers have lights that flash
to indicate connection activity, so you shouldn’t
be concerned if any lights are flashing unless the
manufacturers support information specifically
advises that flashing lights indicate a problem.
8. Hop on one of your computers or Wi-Fi devices
and try to visit a website. If it works, your nbn™
Internet is up and running! If you have issues
connecting, please contact our support team at
support@barefoottelecom.com.au or 1300 017 622
for further troubleshooting.

Other manuals for NetComm NF18ACV

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NetComm NF18ACV and is the answer not in the manual?

NetComm NF18ACV Specifications

General IconGeneral
DSL WANNo
Ethernet WANYes
Wi-Fi bandDual-band (2.4 GHz / 5 GHz)
Wi-Fi standards802.11b, 802.11g, Wi-Fi 4 (802.11n), Wi-Fi 5 (802.11ac)
Top Wi-Fi standardWi-Fi 5 (802.11ac)
WLAN data transfer rate (max)1600 Mbit/s
Networking standardsIEEE 802.11ac, IEEE 802.11d, IEEE 802.11g, IEEE 802.11n
Ethernet LAN data rates10, 100, 1000 Mbit/s
Ethernet LAN interface typeGigabit Ethernet
USB port-
RJ-11 ports quantity2
Ethernet LAN (RJ-45) ports4
Security algorithmsWEP, WPA, WPA-PSK, WPA2, WPA2-PSK
Product typeTabletop router
Product colorWhite
Output current2 A
Output voltage12 V
Power source typeAC
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
Storage relative humidity (H-H)5 - 95 %
Operating relative humidity (H-H)10 - 95 %
Weight and Dimensions IconWeight and Dimensions
Depth28 mm
Width216 mm
Height174 mm
Weight558 g

Related product manuals