TROUBLESHOOTING STEPS
How do I change the wireless channel on my NETGEAR router?
In some regions, not all channels are available. Do not change the channel unless you experience
interference (shown by lost connections or slow data transfers). If this happens, experiment with
different channels to see which is best.
Note: Extenders must use the same channel as your router.
To change the wireless channel:
1. Launch a web browser from a computer or mobile device that is connected to your router’s
network.
2. Enter http://www.routerlogin.net.
A login window opens.
3. Enter the user name and password.
The user name is admin. The default password is password. The user name and password are
case-sensitive.
The BASIC Home page displays.
4. Select Wireless.
The Wireless Settings page displays.
5. From the Region menu, select your region.
In some locations, you cannot change this setting.
6. Select a number from the Channel menu.
7. Click the Apply button.
Your settings are saved.
How do I set C7100V into Pass through/Bridge Mode?
After you install and activate your C7100V modem router, you can put the C7100V into bridge mode
and connect it to a router.
If you want to connect your C7100V to a router and set it up in passthrough mode or bridge mode, you
must disable NAT. With NAT disabled, the modem router works as a bridge and the router behind it
obtains a WAN IP address from the Internet service provider at which point all the routing will be
handled by your router.
To put the C7100V modem router into passthrough mode or bridge mode:
1. Launch a web browser from a computer or mobile device that is connected to the modem router
network.
2. Type http://routerlogin.net or http://192.168.0.1.
To Next Page
Need help?
General
