Technical Support
PLEASE REFER TO THE SUPPORT INFORMATION CARD THAT SHIPPED WITH
YOUR PRODUCT.
By registering your product at www.NETGEAR.com/register, we can provide you with faster
expert technical support and timely notices of product and software upgrades.
NETGEAR, INC.
Support Information
Phone: 1-888-NETGEAR (For US & Canada only) - 24 x7 phone support
See Support Information card for other countries.
E-mail: support@NETGEAR.com (24 x 7 online support)
www.NETGEAR.com
© 2009 NETGEAR, Inc. NETGEAR, the Netgear logo, The Gear Guy, ProSafe, Auto Uplink
and Everybody's Connecting are trademarks or registered trademarks of Netgear, Inc. in the
United States and/or other countries. Microsoft and Windows are registered trademarks of
Microsoft Corporation in the United States and/or other countries. Other brand and product
names are trademarks or registered trademarks of their respective holders. Information is
subject to change without notice. All rights reserved.
December 2009
Introduction
Congratulations on your purchase of the NETGEAR® ProSafe™ 16 Port 10/100 Switch with
8 Port PoE FS116P. This switch provides Power over Ethernet (PoE) capabilities in a small
form factor. Integrating both 100Mbps Fast Ethernet and 10Mbps Ethernet capabilities in a
sturdy, compact package, the FS116P provides 16 ports of standard networking. Ports 1
through 8 of this Switch can provide standards-based PoE, and will automatically detect the
presence of IEEE 802.3af-compliant devices. The switch will provide up to 15.4 W of power
on each PoE port and can be used to drive WLAN access points, IP phones, IP cameras and
other PoE-capable devices. The switch will automatically detect the device's power
requirements, and will supply the required power to each appliance. If you have a problem
with your switch, NETGEAR offers free support 24 hours a day and 7days a week on the
Web (www.NETGEAR.com ), by e-mail (support@NETGEAR.com) and by phone (see the
provided support information card for phone numbers).
Power over Ethernet (PoE)
Power over Ethernet (PoE) integrates power and data onto one single cabling infrastructure,
eliminating the need to have AC power adapters available at all locations. The IEEE 802.3af
standard defines how products should provide and receive power over the data infrastructure. The
FS116P complies with the IEEE 802.3af standard.
Using category 5/5e cable or better, PoE will provide power to PoE compatible devices, such as IP
telephones, wireless LAN access points and IP cameras, for a distance up to 100 Meters. Products
that are powered by PoE are generically called Powered Devices (PD). PoE is already widely
adopted in the market, saving up to 50% of overall installation costs by eliminating the need to
install separate electrical wiring and power outlets in new or hard to reach places.
Installation Overview
Estimated Time: 5-10 minutes
1. Unpack the box and verify the contents.
2. Prepare to install the switch.
3. Install the switch and connect the other devices.
ProSafe™ 16 Port 10/100 Switch with 8 Port PoE FS116P
Installation Guide
Statement of Conditions
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to
make changes to the product described in this document without notice. NETGEAR does not assume any liability that
may occur due to the use or application of the product(s) or circuit layout(s) described here in.
Certificate of the Manufacturer/Importer
It is hereby certified that the NETGEAR ProSafe™ 16 Port 10/100 Switch with 8 Port PoE FS116P has been
suppressed in accordance with the conditions set out in the BMPT-AmtsblVfg 243/1991 and Vfg 46/1992. The
operation of some equipment (for example, test transmitters) in accordance with the regulations may, however, be
subject to certain restrictions. Please refer to the notes in the operating instructions. Federal Office for
Telecommunications Approvals has been notified of the placing of this equipment on the market and has been granted
the right to test the series for compliance with the regulations.
Voluntary Control Council for Interference (VCCI) Statement
Federal Communications Commission (FCC) Compliance Notice: Radio
Frequency Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interferences in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interferences to radio communications. However,
there is no guarantee that interference will not occur in a particular installation if this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
EN 55 022 Declaration of Conformance
This is to certify that the NETGEAR Model ProSafe™ 16 Port 10/100 Switch with 8 Port PoE FS116P is shielded
against the generation of radio interference in accordance with the application of Council Directive 89/336/EEC,
Article 4a. Conformity is declared by the application of EN35 022 Class A (CISPR 22).
Canadian Department of Communications Radio Interference Regulations
This digital apparatus (NETGEAR Model ProSafe™ 16 Port 10/100 Switch with 8 Port PoE FS116P) does not
exceed the Class A limits for radio-noise emissions from digital apparatus as set out in the Radio Interference
Regulations o f the Canadian Department of Communications.
Règlement sur le brouillage radioélectrique du ministère des Communications
Cet appareil numérique (NETGEAR Model ProSafe™ 16 Port 10/100 Switch with 8 Port PoE FS116P) respecte les
limites de bruits radioélectriques visant les appareils numériques de class A rpescrites dans le Reglement sur le
brouillage radioélectrique du mimisére des Communications du Canada.
ProSafe™ 16 Port 10/100 Switch with 8 Port PoE FS116P
MODEL
FS116 P
Fast Ethernet Switch
201-10536-02
To Next Page
Need help?
General
