Installation
Step 1. Connect the equipment.
8-Port Gigabit Switch with 4-Port PoE
GS308P
Step 2. Connect to power. Step 3. Check the status.
Power LED Right PoE LEDs (Ports 1–4) Le Port LEDs (Ports 1–8)
On PoE in use 1000 Mbps
link
O PoE fault 10/100 Mbps
link
No PoE use (o)
Activity
(blinking)
No link (o)
PoE Max LED
Less than 7W of PoE power is available.
PoE Max. LED was activated in the previous two minutes
(blinking.
PoE ports are working normally (o).
GS308P Optional router
Optional modem
IP Phone Server
Internet
To Next Page
Need help?
General
