Need help?Do you have a question about the NETGEAR M4300 Intelligent Edge Series and is the answer not in the manual?
General| Switch Type | Managed |
|---|---|
| Form Factor | Rack-mountable |
| Layer 3 Features | Static routing, RIP, OSPF, VRRP |
| Model | NETGEAR M4300 Intelligent Edge Series |
| Ports | Varies by model |
| PoE | Available on some models |
| Stacking | Yes |
| Redundancy | Redundant power supplies (on some models) |
| Management | Web-based, CLI, SNMP |
| Switching Capacity | Varies by model |
| Forwarding Rate | Varies by model |
| Jumbo Frame Support | Yes |
| Layer 2 Features | VLAN, STP, RSTP, MSTP |
| Security Features | ACL, 802.1X |
| Dimensions | Varies by model (see documentation) |
| Weight | Varies by model (see documentation) |
| Operating Temperature | 0° to 50° C (32° to 122° F) |
| Storage Temperature | -4°F to 158°F (-20°C to 70°C) |
| Power Supply | Internal |
| Warranty | Lifetime |
Outlines essential safety guidelines and warnings for operating the switches.
Details the site requirements and environmental considerations before installing the switch.
Provides essential steps to prevent damage from electrostatic discharge (ESD) during installation.
Provides instructions for installing the switch in a rack or on a flat surface.
Steps to verify the correct installation of the switch before applying power.
Instructions for applying AC power and checking the system LEDs after installation.
Lists common symptoms, their causes, and solutions for troubleshooting the switch.
To Next Page