8. Run the flexible conduit that contains the microwave cable over the top of the rear baler frame and present
to the antennae. You may need an adjustable wrench to tighten the conduit nut inside the antennae.
Secure the conduit in place using large cable ties around the baler frame. Put this cable assembly into
each antenna as described in the Model 870 Owner’s Manual (Section 2.2).
9. Fasten a protection bar to each antenna support frame using the hex head screws supplied. The holes in
these protection bars are tapped. Note the extended end goes up on both sides.
10. Install the baler cable from the active antenna to the tractor cabin where the Gazeeka touchscreen is to
be installed. When running the cable through the baler, make sure that it is clear of any moving parts,
minimisng the chance of the cable being damaged during operation. It is best to follow existing cables
where possible.
11. Install the Gazeeka touchscreen in the preferred position with the RAM mount and fasteners provided.
12. Do not put the spray cans in at this stage.
13. Refer to the Commissioning/Setup section of the Owner’s Manual (Section 2.3).
14. For ISObus loom installation, continue to next page.
To Next Page
Loading...
Need help?
General
