3
EN
Programming warnings
The settings described in this chapter (except for pro-
cedure 6) require use of the key and led on the receiver
(fig. 2). To indicate the state of activity in progress, the
led emits a set number of flashes with a specific dura-
tion and colour (green, red or orange). For the mean-
ing of these signals, refer to Table A at the end of the
manual.
PROGRAMMING THE
MAIN FUNCTIONS
4 – CAUTION! – READ THIS SECTION
BEFORE MEMORISING THE TRANS-
MITTER
The receiver can only memorise transmitters using O-Code/A
or Flo-R/A encoding.
Caution! – Before memorising a transmitter, carefully
read all memorisation procedures described below to
select the one most suited to your specific application.
5 – TRANSMITTER MEMORISATION
PROCEDURE: “Mode I” AND “Mode II”
Each control unit has a set number of commands that can be
activated according to the type of receiver: The models with
“SM” connector provide 4 or 15 commands.
In general the commands can be associated with the trans-
mitter keys in two ways:
• “Mode I”. This mode enables memorisation on the receiver
of all transmitter keys or a group of the latter at once. The keys
are automatically associated with the pre-set commands of
the control unit or the receiver outputs, on models with uni-
versal connectotion.
• “Mode II”. This mode enables memorisation on the receiver
of a single transmitter key. The user can choose to which
command, of those available on the control unit, to assign the
key.
– The available commands are given in the “Commands
Table” (4 or 15 depending on the control unit), included in
the user manual for the control unit to which the receiver is
connected.
2
Led Key
To Next Page
Loading...
Need help?
General
