110
Taking Photographs—Using a Remote Control
Replacing the Battery
The ML-L3 remote control is powered by a three-volt CR2025 lithium battery.
To replace the battery:
1
After sliding the latch in the direction shown
in
to unlatch the battery holder, remove the
holder as shown in
.
2
Remove the battery from the battery holder.
3
Insert a fresh battery with the face marked
“+” on top.
4
Slide the battery holder into the remote until
the latch clicks into place.
Keep out of Reach of Children
Care should be taken to prevent infants from putting the battery or other small parts in
their mouths. Should a child swallow the battery, consult a physician immediately.
To Next Page
Loading...
