Upgrading the Firmware for the
D700
Macintosh
Thank you for choosing a Nikon product. This guide describes how
to upgrade the camera firmware for the D700.
If you are not confident that you can perform the update
successfully, the update can be performed by a Nikon-authorized
service representative.
Important
The camera may be damaged if power is interrupted or camera controls are operated during the
update. Do not turn the camera off, remove or disconnect the power source, or operate camera
controls during the update. If the update is not completed successfully and the camera becomes
inoperable, take the camera to a Nikon-authorized service representative for inspection.
Get ready
To upgrade the camera firmware, you will need:
The camera
A computer equipped with an CF card reader or card slot
One of the following power sources:
An EH-5/EH-5a AC adapter
A fully-charged EN-EL3e rechargeable Li-ion battery
A Nikon-approved memory card that has been formatted in the camera (note that
all data on the memory card will be deleted when the card is formatted; before
formatting the card, back up any data you wish to keep to a computer or other
device).
The camera
User's Manual
To Next Page
Need help?
General
Weight and Dimensions
