NOTE: IF YOU ARE USING THE SAS-1 TO SIMULTANEOUSLY SWITCH BOTH LINE-LEVEL AUDIO AND
VIDEO SIGNALS, AND WANT THE UNIT TO TRIGGER FROM EITHER SOURCE, MOVE BOTH THE “A”
SWITCH AND THE “V” SWITCH UP. IF YOU WANT THE SAS-1 TO TRIGGER FROM EITHER SPEAKER-
LEVEL OR VIDEO SIGNALS, SLIDE BOTH THE “S” SWITCH AND THE “V” SWITCH UP. IF YOU MOVE
ALL THREE SWITCHES UP, THEN THE SAS-1 WILL TRIGGER FROM ANY OF THE THREE SOURCES
VOLTAGE-ACTIVATED MODE
In this mode, the SAS-1 switches from A to B when 5 to 24 Volts (AC or DC) is applied to the
“CONTROL IN” jack. This is not affected by the settings of the DIP switches
To Next Page
Loading...
Need help?
General
