Ninja CM360 User Manual

3
ninjakitchen.com
4
ninjakitchen.com
USING THE CONTROL PANEL PREPARING FOR USE
SETTING THE CLOCK
HIGH-ALTITUDE CALIBRATION BREW
1 Programmable Digital Clock
2 Hour/Minute (H/M) Button
3 WARM Indicator/Button
4 Delay Brew Button
5 Multi-Serve Dial
a Small Cup
b Cup
c XL Cup
d Travel Mug
e XL Travel Mug
f 1/4 Carafe
g Half Carafe
h Full Carafe
6 Custom Brews
a Classic Brew
b Rich Brew
c Over Ice Brew
d Cold Brew
7 Drip Stop Indicator
8 Intelligent Clean Cycle
Indicator/Button
9 Power Button
1
3
5c
5
7
8
5a
5b
6a
6b
6d
6c
24
5e5d
5h
5g
5f
9
1 When the unit is plugged in, the clock will flash on the control
panel to indicate that the time has not been set.
2 Press the H/M button until you reach the current time. The
AM or PM indicator will illuminate on the left side of the
display as you are setting the time.
3 After 5 seconds, the clock will stop flashing and the clock will
be set.
NOTE: If the clock stops flashing and does not display the correct time of day, pressing the H/M
button at any time will cause the clock to flash again. You can now reprogram the correct time by
following the previous steps.
NOTE: If you unplug the coee maker or in the event of a power loss, you will need to reset the clock.
NOTE: Pressing the CLASSIC, OVER ICE, COLD BREW, or Power button will cancel the calibration cycle.
NOTE: Functions and some sizes
may vary by model.
Remove all packaging material and stickers from the coee maker. Wash the water reservoir, carafe,
removable filter holder, and permanent filter (not included on all models) in warm, soapy water with
a soft cloth. Rinse parts and dry thoroughly. Before first use, prime the system by running a Full
Carafe, Classic brew cycle with water only. After the cycle is complete, discard the water. For detailed
instructions, refer to the Priming Your Ninja Hot & Iced Coee Maker section.
PLEASE KEEP THIS IMPORTANT SAFEGUARD IN MIND WHEN USING THE APPLIANCE:
DO NOT run the appliance without water.
Required for users in high-altitude areas. Not running the high-altitude calibration brew in a high-
altitude area will result in excessive steaming during brewing.
Because water boils at lower temperatures at higher altitudes, running a calibration cycle before
your first brew allows the unit to detect the boiling point of water at your location. Running a
calibration cycle will help deliver a consistent brew each time.
1 Fill the water reservoir up to, but not exceeding, the Full line.
2 Place the empty filter holder into the brew basket, and an empty vessel in the machine.
3 Press and hold both CLASSIC and OVER ICE until clock displays CAL.
4 A calibration cycle will begin. When complete, the unit will beep and End will appear on the clock
display. Discard the water in the vessel.
NOTE: This calibration is permanently saved and will not be lost if power is interrupted or brewer
is unplugged. Brewer can be re-calibrated at any time if it is used at a dierent altitude.

Ninja CM360 Specifications

General

Brand	Ninja
Model	CM360
Category	Coffee Maker
Language	English