OPERATION AND ADJUSTMENT
THE PERFORMANT LUBE TM WALKING BELT
Yourtreadmill features a walking belt coated with
PERFORMANT LUBE TM, a high-performance lubricant.
IMPORTANT: Never apply silicone spray or other
substances to the walking belt or the walking plat-
form. Such substances will deteriorate the walking
belt and cause excessive wear.
HOW TO PLUG IN THE POWER CORD
an equipment-grounding conductorand a grounding
plug.Plug the power cord into a surge suppressor,
and plug the surge suppressor into an appropriate
outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
Important: The treadmill is not compatible with
GFCl-equipped outlets.
This product is for use on a nominal 120-volt circuit,
and has a groundingplugthat looks likethe plug illus-
trated in drawing 1 below.A temporary adapterthat
lookslike the adapter illustratedin drawing2 may be
used to connectthe surge suppressortoa 2-pole
receptacle as shownin drawing2 ifa properly
groundedoutletisnot available.
Your treadmill, like any other type of sophisticated
electronic equipment, can be seriously damaged by
sudden voltage changes in your home's power.
Voltage surges, spikes, and noise interference can
result from weather conditions or from other appliances
being turned on or off. To decrease the possibility of
your treadmill being damaged, always use a surge
suppressor with your treadmill (see drawing I at
the right). To purchase a surge suppressor, see
your local NordicTrack dealer or call 1-800-806-
3651 and order part number 146148.
Use only a single-outlet surge suppressor that is
UL 1449 listed as a transient voltage surge sup-
pressor (TVSS). The surge suppressor must have a
UL suppressed voltage rating of 400 volts or less
and a minimum surge dissipation of 450 joules.
The surge suppressor must be electrically rated
for 120 volts AC and 15 amps. There must be a
monitoring light on the surge suppressor to indi-
cate whether it is functioning properly. Failure to
use a properly functioning surge suppressor could
result in damage to the control system of the
treadmill. If the control system is damaged, the
walking belt may change speed or stop unexpect-
edly, which may result in a fall and serious injury.
This product must be grounded. If itshouldmalfunc-
tionor break down, groundingprovidesa path of least
resistancefor electric currentto reduce the riskof elec-
tric shock.Thisproductisequipped witha cordhaving
_Grounded Outlet Box
._.] _ Surge Supprassor
II I% ;:VJ Grounding Pin
Grounded Outlet G_ounding Plug_'_
GroundedOutlet Box
II /fl _) I Adapter Surge Suppressor
Metal Screw _ _,
The temporaryadapter shouldbe used only until a
properly grounded outlet(drawing 1) can be installed
by a qualifiedelectrician.
The green-colored rigid ear, lug, or the like extending
from the adapter must be connected to a permanent
ground such as a properly grounded outlet box cover.
Whenever the adapter is used it must be held in place
by a metalscrew. Some 2-pole receptacle outlet box
covers are not grounded. Contact a qualified elec-
trician to determine if the outlet box cover is
grounded before using an adapter.
8
To Next Page
Loading...
Need help?
General
