Numark M2 User Manual

6
13. Cue Mode Selector: Selects the audio to be routed to the headphones. Switch it to
“Master” to hear the Program mix. Switch it to “CH1 CH2” to hear Channels 1 and 2.
14. Cue Slider: When Cue Mode Selector is set on “CH1 - CH2”, the cue slider blends
between Channel 1 & Channel 2 audio in the headphones. Move this slider to the left to
hear Channel 1, or to the right to hear Channel 2.
15. Crossfader: Blends audio between Channels 1 and 2. Sliding the crossfader to the left
plays Channel 1. Sliding it to the right plays Channel 2.
Note: The crossfader is user-replaceable if it should ever wear out. Simply remove the
facepanel, then remove the screws holding it in position. Replace the fader with a quality
authorized replacement from your local Numark retailer.
16. Crossfader (CF) Mode: Press this button to reverse crossfader assignment of Channels
1 and 2.
17. Crossfader (CF) Slope: Adjusts the slope of the crossfader curve. Flip switch to the left
for a smooth fade (mixing) or to the right for a sharp cut (scratching).
18. Level Indicators: Monitors the audio level of the Program mix (L&R) and the pre-fader
audio levels of Channels 1 and 2 (Cue).
19. Master Volume: Adjusts the output volume of the Program mix.

Numark M2 Specifications

General

Channels quantity	2 channels
Digital sound processing	- bit
Number of EQ bands per channel	3
Record out	1
Line inputs (RCA)	2

Weight and Dimensions

Dimensions (W x D x H) (imperial)	9.5 x 11.4 x 3.6 \