Numark NS6 Service Manual

15. SPLIT CUE – When this switch is in the ON position, the headphone audio will be "split" such that all channels sent to
CUE are mixed to mono and applied to the left headphone channel and the Program mix is mixed to
mono and applied to the right channel. When the switch is in the OFF position, Cue and Program audio
will be "blended" together.
16. CUE BLEND – Turn to mix between Cue and Program in the Headphone channel. When all the way to the left, only
channels routed to CUE will be heard. When all the way right, only the Program mix will be heard.
17. CROSSFADER ASSIGN – Routes the audio playing on the corresponding channel to either side of the crossfader (L
or R), or bypasses the crossfader and sends the audio directly to the Program Mix
(center, "|").
18. CROSSFADER SLOPE – Adjusts the slope of the crossfader curve. Turn the knob to the left for a smooth fade
(mixing) or to the right for a sharp cut (scratching).
19. FADER START – Enables or disables “fader start” on the corresponding side of the crossfader. When fader start is
enabled on one side, moving the crossfader toward that side will cause the Deck to start playing.
STANDARD
1.MaxMSP test program for production Line
2. AP test specification
RCA Balance Output
Voltage AC 100V~240V 50~60Hz
MASTER:2 ± 0.5V
Volume BOOTH:2 ± 0.5V
BALANCED:12 ± 2V
Distortion defection 0.03% below
S/ N 70dBr upward
Separation 70dBr upward
F/R 20~20KHz ± 0.5dB

Numark NS6 Specifications

General

Sample rate	441 kHz
Channels quantity	4 channels
Digital sound processing	24 bit
MIDI out	Yes
Booth out (1/4\")	1
Dimensions (WxDxH)	603 x 340 x 64 mm

Weight and Dimensions

Weight	6330 g