SPECIFICATIONS
MIC – AUX GAIN” (Microphone – Auxiliary Gain): This knob
adjusts the volume of both the main microphone and auxiliary
inputs.
“Treble “ (Microphone – Auxiliary High EQ):This knob adjusts
the high-tone input sound of the microphone.
“Bass” (Microphone – Auxiliary Low EQ): This knob adjusts
the low-tone input sound of the microphone.
“Gain knob” (Input Level Trim): This rotary control adjusts the
pre - fader input signal levels of the inputs.
EQ:
“Treble” (Input Level High EQ): This rotary control adjusts the
high – tone sound of the inputs.
“Middle” (Input Level Midrange EQ): This rotary control adjusts
the high-tone sound of the inputs.
“Bass” (Input Level Low EQ): This rotary control adjusts the
high – tone sound of the inputs.
“Phono(AUX)/Line Switch” (Input Selector Switch): These
three – position toggles select what input source is engaged among
the connected units and a flash position to allow rapid transforming
effect.
“Input Level Slider” (VCA Fader): These slide faders adjust the level
for CH-1 or CH-2 respectively.
“Slope knob” (Input Fader Curve Style Control): The position of this
knob determines the rate of volume level increase of the fader.
“Reverse Button” (Input Fader Reverse Control): Activation of this
switch can reveres the fader direction.
“Program/PFL Level Meter and Button”: Press to alternate display
modes.
“Cue Gain Knob”(Headphone Level): This rotary control adjusts
the levels of the headphones connected to the front panel input.
“Cue Tone Knob” (Headphone Tone Control): This rotary knob
adjusts the tone of the headphone output.
“Channel Cue Slider”: Channels 1 and 2 can be previewed using this
mini – crossfader.
“Cue Button” (MIC and MASTER Cue Buttons): When pressed,
the CUE button illuminates green indicating that the source is
being cued to the headphones.
“Crossfader Slider” (Digital VCA Crossfader): This slide fader
blends audio between CH-1 and CH-2.
SERVICE MANUAL
MODEL:X5
“Contour Knob” (Crossfader Rate/Slope Control): The position of this switch
determines how quickly or intensely the crossfader will act depending upon mode
setting.
“Direction Button” (Crossfader Reverse Control): Activation of this switch
reverses the assignment of CH-1 and CH-2 on the crossfader.
“Master Knob” (Main Output Level Control): This rotary control adjusts the main
output volume.
“Booth Knob” (Master/Split Style Headphone Cueing Switch): This rotary control
adjusts the auxiliary (AKA booth) output volume.
“Digital Output” (Optical): 48kHz, 24-bit S/PDIF output.
“Digital Output” (Coax): 48kHz, 24-bit S/PDIF output.
To Next Page
Need help?
General
