NuTone QTRN Series Quick Start Guide

MODEL SPKACC
Page 3
INSTALLATION WITH “FLAT” MOTOR BRACKET
1. TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS: Switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
2. Remove fan GRILLE by squeezing two GRILLE SPRINGS
and sliding them out of their mounting slots on each side of
the fan housing. Disconnect LIGHT WIRE from fan (if fan is
equipped with a light). Set grille assembly aside for now.
GRILLE
3. Disconnect FAN MOTOR PLUG.
FAN MOTOR PLUG
4. Attach AUXILIARY BRACKET (loose bracket in parts bag)
to SPEAKER BRACKET (attached to SPEAKER MODULE).
Partially install (2) #8-32 X 3/8” SCREWS (short screws
from parts bag) through larger holes in speaker bracket and
into auxiliary bracket - only so ends of screws are flush with
bottom surface of auxiliary bracket. Note: Installing screws
below flush will make the next steps more difficult.
#8-32 X 3/8”
SCREWS
SPEAKER MODULE
AUXILIARY BRACKET SPEAKER BRACKET
5. Insert speaker into fan housing. Make sure AUXILIARY
BRACKET hooks over edge of BRACKET OPENING.
6. Make sure rear surface of speaker is located as close to
wall of fan housing as possible.
7. Secure SPEAKER BRACKET to auxiliary bracket by
tightening the #8-32 X 3/8” SCREWS (partially installed
in Step 4). Alternately tighten both screws. DO NOT
OVERTIGHTEN.
8. Secure speaker to MOTOR BRACKET by installing other
two (2) #8-32 X 3/8” SCREWS into threaded holes in
AUXILIARY BRACKET. Turn screws until they make
contact with the sheet-metal “bump” in the fan opening of
the PARTITION PLATE. Alternately tighten both screws.
DO NOT OVERTIGHTEN.
9. Insert SPEAKER PLUG into power receptacle where
motor plug was disconnected.
10. Connect FAN MOTOR PLUG into SPEAKER WIRE
RECEPTACLE.
11. Plug in LIGHT WIRE (if applicable) and re-install grille that
were unplugged and removed in Step 2.
12. Turn on power to fan.
13. Go to “Bluetooth
®
wireless technology SPEAKER
OPERATION” section for speaker operating instructions.
MOTOR BRACKET OPENING AUXILIARY BRACKET
#8-32 X 3/8”
SCREWS
SPEAKER BRACKET
SPEAKER PLUG
FAN MOTOR PLUG
SPEAKER WIRE
RECEPTACLE
MOTOR
BRACKET
PARTITION
PLATE
GRILLE SPRING
LIGHT
WIRE

NuTone QTRN Series Specifications

General

Brand	NuTone
Model	QTRN Series
Category	Fan
Language	English