NuTone QTRN080L User Manual

Page 3
MODELS QTRN080L • QTRN110L
5. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use
proper UL approved connector to secure house wiring to
wiring plate. Connect wires as shown in wiring diagrams.
CONNECT WIRING
3. Attach
damper/duct
connector.
Snap damper /
duct connector
onto housing.
Make sure con-
PGEVQTKUƀWUJYKVJ
top of housing and
FCORGTƀCRHCNNU
closed.
4. Install
4-inch
round duct-
work.
Connect 4-inch
round ductwork
to damper / duct
connector. Run
ductwork to a
roof cap or wall
cap. Tape all
ductwork connections to make them secure and air tight.
INSTALL HOUSING & DUCT
1. Bend
housing
tabs.
Use a pliers to
bend housing
TABS out to 90
0
.
2. Mount
housing to
joist.
Hold housing
in place so that
the housing
tabs contact the
bottom of the
LQKUV6JGJQWU-
ing mounts with
HQWTUETGYU
or nails. Screw or
PCKNJQWUKPIVQLQKUVVJTQWIJNQYGUVJQNGUKPGCEJOQWPV-
KPIƀCPIGVJGPVJTQWIJJKIJGUVJQNGU016'/QWPVKPI
to I-JOISTUJQYPTGSWKTGUWUGQHSPACERSKPENWFGF
DGVYGGPVJGJKIJGUVJQNGQHGCEJOQWPVKPIƀCPIGCPFVJG
+LQKUV
SPACER
WUGHQTOQWPVKPIVQ+,QKUV
I-JOIST
TABS
INSTALL GRILLE
6. Finish ceiling.
Install ceiling material. Cut out around housing.
7. Attach grille
to housing.
 5SWGG\GITKNNG
springs and insert
them into slots
on each side of
housing.

NuTone QTRN080L Specifications

General

Brand	NuTone
Model	QTRN080L
Category	Fan
Language	English