O Audio BASH User Manual

O Audio 300W BASH
®
Subwoofer Amplifier User’s Manual V1.2 page 8 of 12
Copyright © 2008
Use only one set of audio inputs – either the low level audio inputs (RCA receptacles)
or the high level audio inputs (binding posts).
Low level audio inputs are made via RCA receptacles. The amplifier can accept left
and right channel signals. Single channel connection (such as an LFE output from a
home theater receiver or pre-pro) may be made to either input.
High level audio inputs are made via binding posts. The amplifier can accept
speaker level right and left channel signals.
In the final installation location, please assure that air can flow freely over the
faceplate.
Speaker connections are made using the pre-attached cable. Connect the red wire
to the + terminal on the driver; the black wire to the – terminal on the driver.
DO NOT CONNECT THE AMPLIFIER TO DRIVERS OR DRIVER COMBINATIONS THAT ARE
LESS THAN 4Ù (BASED ON THE DRIVER NOMINAL RATING). Refer to the last Caution
on page 3 for more information.

O Audio BASH Specifications

General

Brand	O Audio
Model	BASH
Category	Amplifier
Language	English