Cleaning the Facial Interface (foam)
Cleaning the foam-based facial interface of the Oculus Go is vital when a single headset is being
utilised by multiple users. Thankfully, cleaning an Oculus Go headset is simple. Please note: this may
require multiple wipes.
1. Lift the plastic arms holding the strap into a vertical position.
2. Remove the Facial Interface from the Oculus Go headset. With the inside of the headset (with
the lenses) facing you, grab the left-side of the foam and pull towards the right, the foam
should simply slide out from under the lenses.
3. Wipe the Dark side of the Facial Interface with an anti-bacterial wipe. Be sure to deeply clean
the top of the Facial Interface (which makes contact with the forehead), as well as the
bottom-middle areas (which make contact with the cheek bones); these are the key areas
where cleaning is pivotal.
To Next Page
Need help?
General
