ENGLISH - 1
C831 - Installing Additional RAM
Install additional RAM to increase the memory
capacity of your printer in cases such as if
occur. Your printer supports 256 MB and 512 MB
RAM.
Note
� Use only genuine Oki Data products. The performance
cannot be guaranteed when using other products.
� The static electricity may damage parts. Discharge the
static electricity from your body by touching grounded
metallic parts, etc., before work.
Memo
� For banner printing, installing additional memory is
recommended.
1 Turn off your printer, and then unplug
the AC cord and Ethernet or USB cable.
Reference
� “Turning Off the Power” P.22
2 Open the access cover (1) on the right
side of a printer.
1
(2) Pinch the lower part of the metal
plate (2), and pull it forward.
2
4 Make sure the LED (3) indicated by the
arrow turns off. If it is lit, wait until it
turns off.
3
3 Slide the metal plate (2) upward to
remove.
Note
� If the SD memory card socket is attached, remove
the SD memory card.
(1)
metal plate (2), and slide it upward.
2
5 Insert the additional RAM (4) into the
printer.
Note
� Be sure to check a direction of an additional RAM.
The additional RAM has small dents on its connector,
4
6 Install the metal plate (2).
(1) First, insert the upper part of the
metal plate (2) in the printer, then
install the metal plate.
2
To Next Page
Need help?
General
