39
Connecting the camera to a computer
4
Note
• Operation is only guaranteed on a Macintosh equipped with a built-in USB port.
• QuickTime 6 or later and Safari 1.0 or later should be installed on your computer.
• Be sure to remove the media (drag & drop onto the trash icon) before performing
the following operations. Failure to do so could result in unstable computer
operation and the need to reboot.
• Disconnect the cable connecting the camera to the computer.
• Turn off the camera.
• Open the camera’s battery compartment/card cover.
Windows
1 Insert the CD-ROM into the CD-ROM
drive.
• The OLYMPUS Master setup screen is
displayed.
• If the screen is not displayed, double-click
the “My Computer” icon and click the CD-
ROM icon.
2 Click “OLYMPUS Master”.
• The QuickTime installation screen is
displayed.
• QuickTime is required to use OLYMPUS
Master. If the QuickTime screen is not
displayed, QuickTime 6 or later is already
installed on the computer. In this case, go to
step 4.
3 Click “Next” and follow the on-screen
instructions.
• When the QuickTime licensing agreement is
displayed, read the agreement and click
“Agree” to proceed with the installation.
• The OLYMPUS Master installation screen is
displayed.
To Next Page
Loading...
Need help?
General
